2. EL 9
  3. gpsd-minimal-clients
  4. gpscat(1)

Scroll to navigation

GPSCAT(1) GPSD Documentation GPSCAT(1)

NAME

gpscat - dump the output from a GPS

SYNOPSIS

gpscat [OPTIONS] file-or-serial-port

gpscat -h

gpscat -V

NOTE

Eurolinux support for this package is limited. %{note2}

DESCRIPTION

gpscat is a simple program for logging and packetizing GPS data streams. It takes input from a specified file or serial device (presumed to have a GPS attached) and reports to standard output. The program runs until end of input or it is interrupted by ^C or other means. It does not terminate on a bad packet; this is intentional.

In raw mode (the default) gpscat simply dumps its input to standard output. Nonprintable characters other than ASCII whitespace are rendered as hexadecimal string escapes.

In packetizing mode, gpscat uses the same code as gpsd(8)'s packet sniffer to break the input into packets. Packets are reported one per line; line breaks in the packets themselves are escaped.

This program is useful as a sanity checker when examining a new device. It can be used as a primitive NMEA logger, but beware that (a) interrupting it likely to cut off output in mid-sentence, and (b) to avoid displaying incomplete NMEA sentences right up next to shell prompts that often contain a $, raw mode always emits an extra final linefeed.

Also, be aware that packetizing mode will produce useless results -- probably consuming the entirety of input and appearing to hang -- if it is fed data that is not a sequence of packets of one of the known types.

OPTIONS

The program accepts the following options:

-?, -h, --help

Display program usage and exit.

-D LVL, --debug LVL

In packetizer mode, enable progress messages from the packet getter. Probably only of interest to developers testing packet getter changes. Higher arguments to -D produce more output.

-p, --packetizer

Invoke packetizer mode.

-s SPEED, --speed SPEED

Set the port’s baud rate (and optionally its parity and stop bits) to SPEED before reading. Argument should begin with one of the normal integer baud rates (300, 1200, 4800, 9600, 19200, 38400, etc.). It may be followed by an optional suffix [NOE][12] to set parity (None, Odd, Even) and stop bits (1 or 2). Specifying -s 4800N1 is frequently helpful with unknown devices.

-t, --typeflag

Invoke packetizer mode, with the packet type and length (in parentheses) reported before a colon and space on each line.

-V, --version

Display program version and exit.

RETURN VALUES

0

on success.

1

on failure

SEE ALSO

gpsd(8), gps(1), gpsfake(1). cgps(1)

RESOURCES

Project web site: <https://gpsd.io/>

COPYING

This file is Copyright 2013 by the GPSD project
SPDX-License-Identifier: BSD-2-clause

AUTHOR

Eric S. Raymond

2023-01-10 GPSD Version 3.25